Abstract
Mechanical properties, structure and degree of saturation, with gases of wire from the alloy of ПТ-7св after isothermal drawing are investigated. Influence of temperature and extraction at the isothermal drawing on the change of foregoing sizes is studied. Influence of temperature, strain-rate, deformation parameters of drawing and modes of etching on the size of maximum rejections of diameter of wire is exposed.
References (8)
1. V.N. Trifonov. Doklady 1-oi Mezhdunarodnoi nauchnotekhnicheskoiconferencii po titanu stran SNG. VILS M.:(1994) 617 p. (in Russian) [В.Н. Трифонов. Доклады 1-ойМеждународной научно-технической конференциипо титану стран СНГ. М.:ВИЛС. (1994) 617 c.].
2. A.S. Anish’enko. Voprosy materialovedenyia. 2, 4553(1995). (in Russian) [Анищенко А.С. Вопросы материа-ловедения. 2, 45 (1995).].
3. T. Furushima, K. Manabe, T. Sakai. Materials Transactions49 (6), 1365 (2008).
4. T. Furushima, K. Manabe. Journal of the Japan Society forTechnology of Plasticity. 48 (552), 51 (2007).
5. Thermo-Mechanical Investigation of Dieless WiredrawingProcess by Hani Jafari B.A. Eastern MediterraneanUniversity. 2008. A thesis submitted in partial fullfilmentof the requirements for the degree of master of appliedscience. (2013) 111 р.
6. O.M. Smirnov. Obrabotka metallov davleniem v sostoianiisverkhplastichnosti. M.:Mashinostroenie. (1979) 186p. (in Russian) [Смирнов О.М. Обработка метал-лов давлением в состоянии сверхпластичности. М.:Машиностроение. (1979) 186 с.].
7. A.B. Ivantsov, V.G. Ryzhkov. Analyticheskyi obzorpublikatsiy po besfiliernomu volocheniu provoloki.Obrazovanie. Nauka. Proizvodstvo. Sbornik nauchnykhtrudov. 3, 72 (2007). (in Russian).
8. I.N. Nedovizyi, A.A. Tarnavskyi. Skorostnoe volochenienizkolegirovannoi stalnoi provoloki. M.: Metallurgizdat.(1954) 188 p. (in Russian) [И.Н. Недовизий, А.А Тарнавский. Скоростное волочение низколеги-рованной стальной проволоки. М.:Металлургиздат.(1954) 188 с.].