Effect of the shortening on formation welding under linear friction welding

M.V. Karavaeva, S.K. Kiseleva, V.M. Bychkov, A.Y. Medvedev, A.V. Supov, F.F. Musin, I.V. Alexandrov, V.V. Latysh show affiliations and emails
Received  13 March 2012; Accepted  29 March 2012
This paper is written in Russian
Citation: M.V. Karavaeva, S.K. Kiseleva, V.M. Bychkov, A.Y. Medvedev, A.V. Supov, F.F. Musin, I.V. Alexandrov, V.V. Latysh. Effect of the shortening on formation welding under linear friction welding. Lett. Mater., 2012, 2(1) 40-44
BibTex   https://doi.org/10.22226/2410-3535-2012-1-40-44

Abstract

The effect of the shortening under linear friction welding on the microstructure in the welding zone of two-phase titanium alloys VT6 and VT8M-1 was investigated. It was found that shortening under linear friction welding determines the quality of welded joints. Linear friction welding with shortening 0,4 mm does not provide quality of the welded joint receiving, resulting to the failure in the joint place under a tensile test. For the compression value 1,4 mm and more a failure occurs in the base metal.

References (4)

1. A. Varis, M. Frost. Mat. Sci. Eng. A271, 477 (1999).
2. W.-Y. Li, T.J. Ma, S.Q. Yang. Mat.letters 62, 293 (2008).
3. Wen-Ya Li., T. Ma, J. Li. Mater. Design. 31, 1497 (2010).
4. T. Mohandas, D. Banerjee, V.V. Kutumba Rao. Mater. Sci.Eng. A289, 70 (2000).

Cited by (4)

1.
A. Ducato, D. Campanella, G. Buffa, L. Fratini. KEM. 639, 451 (2015). Crossref
2.
A.U. Medvedev, V.R. Galimov, I.M. Gatiyatullin, O.V. Murugova. SSP. 303, 175 (2020). Crossref
3.
A.P. Zhilyaev, R.M. Kashaev, A.M. Khusnullin, G.I. Raab, J. Calvo, J.M. Cabrera. REVIEWS ON ADVANCED MATERIALS SCIENCE. 57(1), 104 (2018). Crossref
4.
I. Gatiatullin, V. Galimov, A. Medvedev, D. Karetnikov. IOP Conf. Ser.: Mater. Sci. Eng. 1155(1), 012040 (2021). Crossref

Similar papers