Structure, mechanical properties and strengthening mechanisms of rapidly quenched Al-based ribbons consolidated by high pressure torsion processing

E.A. Sviridova ORCID logo , V.N. Varyukhin, S.V. Vasiliev ORCID logo , V.M. Tkachenko, V.I. Tkatch показать трудоустройства и электронную почту
Получена  07 октября 2024; Принята  05 ноября 2024
Эта работа написана на английском языке
Цитирование: E.A. Sviridova, V.N. Varyukhin, S.V. Vasiliev, V.M. Tkachenko, V.I. Tkatch. Structure, mechanical properties and strengthening mechanisms of rapidly quenched Al-based ribbons consolidated by high pressure torsion processing. Письма о материалах. 2024. Т.14. №4. С.425-431
BibTex   https://doi.org/10.48612/letters/2024-4-425-431

Аннотация

The microhardness of the disks composed of amorphous and crystalline ribbons became higher than microhardness of the more solid disks consisted of amorphous ribbons due to formation of additional stresses in crystalline ribbon during vortex-like mixing of the materials with different hardness.The influence of high-pressure-torsion (HPT) processing on the structure and hardness of laminated disks consolidated from rapidly solidified ribbons of Al86Ni9Gd5 and Al95.8Mn3.8Fe0.4 alloys with amorphous and crystalline structures, respectively, as well as from their combination was studied using X-ray diffraction (XRD) analysis, scanning electron microscopy and microhardness measurements. The effect of the HPT deformation by unconstrained and constrained schemes on the changes of concentration of supersaturated Al-based solid solution in the as-prepared Al95.8Mn3.8Fe0.4 ribbon was found. The experimentally established increase in hardness of disks consolidated from crystalline ribbons as a function of the level of deformation was quantitatively analyzed within the additive model. The contributions of grain boundary, dislocation and solid solution strengthening mechanisms were determined using the values of sizes of coherently scattering domains, microstrains and solid solution concentration found from the XRD data. The changes in the hardness of disks consolidated from Al86Ni9Gd5 amorphous ribbons due to the formation of a nanocomposite structure were measured. An increase in the hardness of disks consolidated from amorphous and crystalline ribbons above the hardness value that harder disks with a nanocomposite structure was established and a possible reason of this effect caused by additional microstrains in the crystalline material due to mixing, was discussed.

Ссылки (37)

21. K. A. Svyrydova, T. V. Tsvetkov, V. M. Tkachenko, A. I. Limanovskii, V. N. Sayapin, S. V. Vasiliev, V. I. Tkatch, Structure and mechanical properties of rapidly cooled Al-based alloys consolidated by high pressure torsion technique, Transactions of the Kola science centre. Chemistry and materials 12 (2021) 219 - 225. (in Russian) [Е. А. Свиридова, Т. B. Цветков, В. М. Ткаченко, А. И. Лимановский, В. И. Саяпин, С. В. Васильев, В. И. Ткач, Структура и механические свойства быстроохлажденных сплавов на основе алюминия, консолидированные методом кручения под высоким давлением, Труды Кольского научного центра РАН. Химия и материаловедение 12 (2021) 219 - 225.]
23. S. S. Gorelik, Yu. A. Skakov, L. N. Rastorguev, X-Ray and Electron-Optical Analysis, MISIS, Moscow, 2002, 357 p. (in Russian) [С. С. Горелик, Ю. А. Скаков, Л. Н. Расторгуев, Рентгенографический и электронно-оптический анализ, МИСиС, Москва, 2002, 357 с.].
24. G. V. Samsonov (Ed), Properties of the elements. Handbook. Part 1, Metallurgy, Moscow, 1976, 600 p. (in Russian) [Г. В. Самсонов (Ред), Свойства элементов. Справочник. Часть 1, Металлургия, Москва, 1976, 600 с.].
25. N. P. Lyakishev (Ed), Diagrams of the state of double metal systems. Handbook, Mechanical engineering, Moscow, 1996, 992 p. (in Russian) [Н. П. Лякишев (Ред), Диаграммы состояния двойных металлических систем. Справочник, Машиностроение, Москва, 1996, 992 с.].
26. A. A. Yakunin, I. I. Osipov, V. I. Tkatch, A. B. Lysenko, The effect of melt quenching and heat treatment on the structure and properties of aluminum-manganese alloys, Phys. Metals Metallogr. 43 (1977) 140 -144. (in Russian) [А. А. Якунин, И. И. Осипов, В. И. Ткач, А. Б. Лысенко, Влияние закалки из расплава и термической обработки на структуру и свойства сплавов алюминий-марганец, Физ. мет. металловед. 43 (1977) 140 -144.].